MOLD AND DIRT REMOVER

RANGE OF APPLICATION

The remover is intended for effective and fast removal of mould, dirt and soap residues from bathtubs, sinks, toilets, tiles and joints, as well as from the surface of other products made of plastic, glass, metal, stone or concrete.

PROPERTIES

Thanks to a balanced combination of surfactants, chlorine oxidizers and stabilizers, the product ensures the destruction of bacteria, fungi, mould spores and black plaque in places with high humidity both inside and outside the premises. It eliminates unpleasant odours, has strong washing and bleaching properties, ensures cleanliness and disinfection. Due to the special foam design of the trigger, the product is convenient to apply on a dirty surface.

METHOD OF APPLICATION

Before use, check the stability of the paint or coating to the product on an inconspicuous area of the surface. Pour the product into a spray bottle. Apply the product to a spot of mould or dirt. Allow it to work for a few minutes or until the active foam settles, rub thoroughly with a sponge and rinse with plenty of water. To remove old stains, it is recommended to repeat the procedure. After use, rinse the spray net with water.

Note: For long-term protection and prevention of mould re-formation, the manufacturer recommends that the surface be thoroughly washed with water after using this product, and then treated with “SAN CLEAN” disinfectant.

CAUTION, CAUSTIC! WORK WITH RUBBER GLOVES. DO NOT SPRAY IN THE EYES, IN CASE OF CONTACT WITH THE SKIN OR EYES, RINSE WITH PLENTY OF WATER FOR 15 MINUTES AND CONSULT A DOCTOR. IF YOU FEEL THE EFFECT OF VAPOURS, GO OUT INTO THE FRESH AIR AND VENTILATE THE ROOM. DO NOT EAT. KEEP AWAY FROM CHILDREN. DO NOT MIX WITH OTHER PRODUCTS.

COMPOSITION

Demineralized water, non-ionic surfactants: less than 5%, active chlorine: less than 5%, sodium hydroxide, EDTA: less than 5%. It does not contain phosphates.